Filter by Geographic Location


Recent Uploads

A prop that should work on a trolling motor. The mounting hole has to altered to whatever model you have, those are in the begining and commented out. During the scetion where the mounting hole is removed from the solid part, I would reccomend removing a triangle so that the ends of the prop...

Heliostat is a device which points at Sun so that it could be used so track the solar power through Solar Panel. The solar panel holder and stand was designed on Openscad. Arduino was interfaced with the photoresistor used as a sensor to track the sun light. Arduino moves the servos connected to...

Fairlead designed to be duplicated, flipped and epoxied together. Fairlead for snowboarding winch rope.

This model is designed for the average outdoor floodlight with a photoresistor. At my house, I have several of these lights, and when one turns on, it shuts the others off. This design limits the angle of light exposure to each light.

The plastic cover for a Yoke on an airplane.  Full Yoke is $150

Printed in 2 pieces, tiered 'plates' with prongs on the top plate for holding necklaces. For people who don't want to pin their jewelry into something when they put it away. If the prongs are removed from the stand this could be converted into a serving dish.

Printable guides to add to a small cutting board, allows for even and consistant slices of freashly baked bread.

An adjustable stand for holding up a Christmas tree.  Parameter within the OpenSCAD file can be changed to accomadate different size tree trunks and leg length.

This is a stand for any tablet and bluetooth keyboard combination. Simply print one of each and a mirrored version of each and assemble with a bolt and screw. This is adjustable by using the variables at the top to change length, width, depth, and shell thickness of your print. A typical cheap...

Whether artrhitis, carpal tunnel, or a broken arm is preventing you from finishing your current project, this crochet hook holder could be the solution.  This device allows you to mount your hook and hold the holder firmly between your thighs and alow you fully functioning hand and arm to...

It's a model for aircraft that can be printed by 3D printer. There are 3 parts, offering enough space for control board and motor as well as all the wires. Also an open window is designed for the control board in order to connect  extra equipments to free pins, for example, a camera. The...

A 3D Printed wine glass holder using the RepRap Delta model 3 d printer with PLA filament. the holders are easy to print and can be attached under a shelf or cupboard by 3/16" bolts and nuts for simplicity. A general wine glass holder can cost anywhere around 75 to 200 dollars, but this 3d printed...