Newest Uploads


Just for fun.

Printed in 2 pieces, tiered 'plates' with prongs on the top plate for holding necklaces. For people who don't want to pin their jewelry into something when they put it away. If the prongs are removed from the stand this could be converted into a serving dish.

Batman's Equipment

Upload # 818
Licensing: Attribution - Non Commercial - Share Alike - CC BY - NC - SA
Attribution Link:
Slicer: Cura 14.07
Printer Used: MOST Delta
3D Software: OPENSCAD
Support Material: Yes
About Author:
Member Since: Dec 9, 2014
Location: Michigan, USA
More by Author


The parts I didn't not 3D print for Batman's Equipment is 1/8 diameter steel rod, which I used as dowels for the utility belt, cardboard boxes for the belt pockets, elastic bands I used for the boxes and are also in the mask, and a plastic buckle...