Search

Categories

Newest Uploads

This product is paramedic, so you can change it to fit with whatever wheel size you have. The material costs less around $1 for my wheel size, and will vary slightly with how big of a wheel you print it for.  Both pieces are press fit into inner cylindrical surfaces of the wheel...

Pistol grip and picatinny rail for use on a Mossberg 500 12 gauge. May be usable with other Mossberg models. Printed with a 25% infill with supports touching base. Feels solid but has not been tested yet.

This hockey tape case/dispensor will protect hockey tape from getting dirty when tossed in a hockey bag as well as provide a cutting edge to rip the tape when taping up your stick.

Phone mount for a Droid Turbo, allows the user to make longboarding videos. There is no Droid specific mount as far as I know; most people tend to use Gopro's. Most board mounts on the market mount with screws through the deck or mount a camera below the deck. This mount attaches using the...

AR15 Freefloat Handguard


Upload # 946
Licensing: Public Domain (Unlicense)
Infill: 25
Slicer: Cura
Printer Used: Rep Rap 2
3D Software: FreeCAD
Layer Height: 0.1 mm
Support Material: No
About Author:
Member Since: Dec 8, 2015
Location: Wisconsin, USA
More by Author

Description

This is a freefloat handguard of a AR-15 rifle. It is 7 inches long and works best for an AR pistol. With a 25% infill there is 106 g of fillament used. Using hatchbox fillament from amazon the final cost came out to be $2.33 compared to a retail...



Comments