Search

Categories

Newest Uploads

This aims at providing a way to automate zoom on DSLR manual lens. The main drive for this project is to allow completly autonomous camera control through software. This uses a NEMA 17 stepper motor mounted with 4x 10mm M3 bolts. A standard skate bearing is held in place with a 1 inch 5/16...

This is a design I made to house our enterprise project. We needed a case that was light and as compact as possible. We are also designing the circuity and needed to be able to easily modify the the case to fit with our components and buttons. The case is easily scalable and worked well for our...

The design is for an Open Source Four Point Probe (OS-4PP) used for electrical characterization of thin films ( sheet resistance measurements). The holder consist of two main components; i). The holder ring and,  ii). The carriage. The carriage is attached to the modified 3D printer stage...

Custom case for WCE WIMMS Project - Receiver Pack


Upload # 830
Licensing: Public Domain (Unlicense)
About Author:

rmputzig

Member Since: Dec 9, 2014
Location: Michigan, USA
More by Author

SCAD / STL Files

20141209_receiver_pack_v10_inside.stl

Download stl
20141209_receiver_pack_v10_outside.stl

Download stl
20141209_receiver_pack_v10.scad

Download scad Download stl

Description

This is a design I made to house our enterprise project. We needed a case that was light and as compact as possible. We are also designing the circuity and needed to be able to easily modify the the case to fit with our components and buttons. The case is easily scalable and worked well for our needs.  The cost of a simlar sized uncustomized pack is about $7 and I would estimate that having the case manfactured anywhere would be at least $200. The ability to quickly change the design and print a new prototype alone made this project valuable to our enterprise team.



Comments