UNTESTED SO FAR!
xxdanmurphyxx designed a reinforced (left) NEMA 17 motor mount and published it on Thingiverse (as CC-BY).
As the motor shaft position is important for CoreXY mechanics and he didn't mention which other mount to use, I took out the raise here.
Mirroring has to be done in the...
Gottlieb drop target. Hope this helps someone!
Test piece for speed, jerk, acceleration as well as ringing, vibration, vertical banding and other artefacts.
Ran some tests on my CoreXY printer with two " Test part to look at X and Y damping and resonance by MiseryBot", but realized, that it was too small.
This part has the 45° and...
To re-arm my TronXY X5S, I am currently rethinking the belt paths of the CoreXY mechanism. As I always publish my tinkering on that machine, I had to completely re-engineer the Y-Gantry (instead of just re-mixing an existing part).
Plainly spoken: Lee Brumfield did a good, reduced to the...