Newest Uploads

UNTESTED SO FAR! xxdanmurphyxx designed a reinforced (left) NEMA 17 motor mount and published it on Thingiverse (as CC-BY). As the motor shaft position is important for CoreXY mechanics and he didn't mention which other mount to use, I took out the raise here. Mirroring has to be done in the...

Test piece for speed, jerk, acceleration as well as ringing, vibration, vertical banding and other artefacts. Ran some tests on my CoreXY printer with two " Test part to look at X and Y damping and resonance by MiseryBot", but realized, that it was too small. This part has the 45° and...

Vote on this Listing

To enter your vote please fill in all of the fields below. You may only leave one vote per listing:

You must be logged in to vote.