Newest Uploads

UNTESTED SO FAR! xxdanmurphyxx designed a reinforced (left) NEMA 17 motor mount and published it on Thingiverse (as CC-BY). As the motor shaft position is important for CoreXY mechanics and he didn't mention which other mount to use, I took out the raise here. Mirroring has to be done in the...

Test piece for speed, jerk, acceleration as well as ringing, vibration, vertical banding and other artefacts. Ran some tests on my CoreXY printer with two " Test part to look at X and Y damping and resonance by MiseryBot", but realized, that it was too small. This part has the 45° and...

All uploads for: AdamPringle

Photo Title
Variable Holder Clamp

This variable holder clamp was designed to hold a computer headset on the edge of a table for convenient storage. It is parametric in almost every setting. While it is meant for being attached to a horizontal table or desk edge, it can be applied to a vertical standing edge with reasonable grip and holding capability. It is mostly PLA with two metal components(nut and bolt M10). The metal parts were included to ensure long lasting grip without creep within the PLA weakening the compressive stresses over time.  Additionally the number of holes which can have accessories attached is...

3d Printed, Clamp, Holder, Hooks