Sort By:   GridListGallery

 Vehicles

Gear Shift Knob - Peugeot 306
 : 1 |   : 0

I made this 3D model of the gear shift knob (pommeau de vitesse), for the Peugeot 306. It fits very well in the metal gear lever.

Clapet anti-retour
 : 1 |   : 0

Ici il s'agit d'un système de purge du circuit de freinage. Normalement, il faut être 2, un appui sur le pédale et l'autre qui serre ou desserre sur la purge au niveau des commandes. Avec cet appareil, vous pouvez faire tout seul. ...

Adhesive windshield mount for Transcend DrivePro 200
 : 3 |   : 0

As I wanted that dashcam mounted closer to the top of the window, I designed this mount in Tinkercad. In case someone just needs the latch, it is kept seperately. Description see: https://burningbecks.wordpress.com/2016/07/16/velcro-hot-glued-dashcam-not-anymore/ Tinkercad: ...

Butterfly Handlebars for bike
 : 2 |   : 0

This is a 25.4 mm diameter butterfly handlebars. This came in 3 parts. The middle part, the left side, and the right side. To assemble, just press the parts together. It might be a little harder to push it together, but once fitted together, it will be really hard to break them apart.

Yoke Cover
 : 1 |   : 0

The plastic cover for a Yoke on an airplane.  Full Yoke is $150

Open-Source ORV Light
 : 4 |   : 0

This is an ORV light designed for a 6 inch reflector to replace that of a rusting or rotting commercial one. Replacements can cost from $30-$150 dollars depending on what lamps are used. It is especially good for corrosive, cool environments. This print costs about $4 in filament and offers a cost...

Arctic Cat High Flow Intake
 : 2 |   : 0

Shown here is a fully printable high flow air box intake for an 2005-2011 Arctic Cat M6, M7, and M8.  This intake is very simlar to the product commercially available that costs any where from $60-$80 plus shipping. The new intake is larger, allowing for more air to pass through and supposeds...